Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM › from 2021.02
RM33A0E _53 Suspension _065361 FRONT SUSPENSION _0461872 FRONT LOWER SUSPENSION ARM A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 48069 1.INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

a.

Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.


b.
C370078N01
0.792,0.49 0.958,0.667 0.167,0.177 10 true 1 1.448,0.333 1.615,0.51 0.167,0.177 10 true 2 2.375,1.177 2.542,1.354 0.167,0.177 10 false 3

Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration.

Torque:
Bolt (1), (2) : 200 N*m (2039 kgf*cm, 148 ft.*lbf)
Bolt (3) : 135 N*m (1377 kgf*cm, 100 ft.*lbf)

NOTICE:

Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.



c.

Connect the front lower No. 1 suspension arm sub-assembly to the front lower ball joint assembly with the bolt and 2 nuts.

Torque:
92 N*m (938 kgf*cm, 68 ft.*lbf)


Hide 58166A 3.INSTALL FRONT FLOOR COVER LH (for A25A-FKS)

Hide 51442 4.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY (for A25A-FKS)

Hide 51441 5.INSTALL NO. 1 ENGINE UNDER COVER (for A25A-FKS, M20A-FKS)

Hide 53852K 6.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for A25A-FKS, M20A-FKS)

Hide 53851M 7.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for A25A-FKS, M20A-FKS)

Hide 8.INSTALL FRONT WHEEL

Hide 9.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Hide 10.PERFORM INITIALIZATION

Parking Support Brake System (Click here)
Parking assist monitor system for Initialization:(Click here)
for Calibration:(Click here)
Panoramic view monitor system for Initialization:(Click here)
for Calibration:(Click here)
Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System) (Click here)