1. PRECAUTION
When performing the following work, the navigation system may restart when turning the ignition switch ACC (due to radio and display receiver assembly and navigation ECU certification).
Repair or replace the negative (-) battery terminal due to it being disconnected or depleted.
The radio and display receiver assembly or navigation ECU replacement or removal and installation.
After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION
55900
2.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
55405B
3.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 7 Inch Display)
55405B
4.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 9 Inch Display)
5.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55476C
6.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH
55434B
7.REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
33554C
8.REMOVE SHIFT LOCK RELEASE BUTTON COVER
for UA80E:
Click hereDrivetrain>UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER>REMOVAL
for UB80E:
Click hereDrivetrain>UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER>REMOVAL
for K120:
33504F
9.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
for UA80E:
Click hereDrivetrain>UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER KNOB>REMOVAL
for UB80E:
Click hereDrivetrain>UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER KNOB>REMOVAL
for K120:
58805C
10.REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
11.REMOVE NAVIGATION ECU WITH BRACKET
| *A | w/ Manual (SOS) Switch |
Disconnect each connector.
Remove the 3 bolts.
Disengage the 3 guides.
for LHD:
Disengage the clamp.
for RHD:
Disengage the clamp.
Disconnect each connector and remove the navigation ECU with bracket.
86101M
12.REMOVE ANTENNA CORD SUB-ASSEMBLY
w/o Manual (SOS) Switch:
Disconnect the connector.
Disengage the clamp to remove the antenna cord sub-assembly.
w/ Manual (SOS) Switch:
| *A | w/ Digital TV Function |
Disconnect each connector.
Disengage the clamp to remove the antenna cord sub-assembly.
86719B
13.REMOVE NO. 2 TELEPHONE BRACKET
w/o Manual (SOS) Switch:
Remove the 2 screws and No. 2 telephone bracket.
w/ Manual (SOS) Switch:
Remove the 3 screws and No. 2 telephone bracket.
86719A
14.REMOVE NO. 1 TELEPHONE BRACKET
w/o Manual (SOS) Switch:
Remove the 2 screws and No. 1 telephone bracket.
w/ Manual (SOS) Switch:
Remove the 3 screws and No. 1 telephone bracket.
15.REMOVE TELEMATICS TRANSCEIVER (w/ Manual (SOS) Switch)
86841
16.REMOVE NAVIGATION ECU