The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.
28800
1.REMOVE BATTERY
89661
2.REMOVE ECM
74404A
3.REMOVE BATTERY CLAMP SUB-ASSEMBLY
17410
4.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
58152A
5.REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
Remove the 2 nuts and front lower No. 1 floor heat insulator from the vehicle body.
6.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY
58861B
7.REMOVE NO. 1 CONSOLE BOX DUCT
Remove the No. 1 console box duct.
33820B
8.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
| *a | Clip |
| *b | 45° to 60° |
While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip.
Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
Remove the 2 nuts and disconnect the transmission control cable assembly from the vehicle body.
Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.