The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during central gateway ECU (network gateway ECU) removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1. PRECAUTION (for LHD)
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for LHD)
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for LHD)
Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If an airbag deploys for any reason, it may cause a serious injury.
55435B
4.REMOVE NO. 1 METER HOOD CLUSTER (for LHD)
55012A
5.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (for LHD)
55476C
6.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for LHD)
67913
7.REMOVE FRONT DOOR SCUFF PLATE RH (for LHD)
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62111A
8.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for LHD)
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62311B
9.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH (for LHD)
55317A
10.REMOVE INSTRUMENT SIDE PANEL RH (for LHD)
55607
11.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
73990
12.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD, w/ Passenger Side Knee Airbag)
55303B
13.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for LHD, w/o Passenger Side Knee Airbag)
55303B
14.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for LHD, w/ Passenger Side Knee Airbag)
82877
15.REMOVE ECU INTEGRATION BOX RH (for LHD)
Disconnect each connector.
Disengage the 2 clamps.
Remove the bolt, nut and ECU integration box RH.
89111
16.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (for LHD)
Disengage the 2 claws and remove the central gateway ECU (network gateway ECU).
If the ECU integration box is deformed or damaged, replace it.
Do not bend the 2 claws more than necessary.
73900
17.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)
55308B
18.REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY (for RHD)
Use the same procedure as for LHD.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>REMOVAL
82877
19.REMOVE ECU INTEGRATION BOX RH (for RHD)
Disconnect each connector.
Disengage the clamp.
Remove the bolt, 2 nuts and ECU integration box RH.
89111
20.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) (for RHD)
Disengage the 2 claws and remove the central gateway ECU (network gateway ECU).
If the ECU integration box is deformed or damaged, replace it.
Do not bend the 2 claws more than necessary.