This DTC is stored when the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) detects that the panoramic moon roof switch (roof console box sub-assembly) is stuck for 30 seconds or more.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2342 | Switch Failure | Sliding roof ECU (sliding roof drive gear assembly) detects panoramic moon roof switch (roof console box sub-assembly) is stuck for 30 seconds or more. | ·
Sliding roof ECU (Sliding roof drive gear assembly) ·
Panoramic moon roof switch (Roof console box sub-assembly) ·
Wire harness or connector |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2342 | Switch Failure | Roof sunshade ECU (sliding roof drive gear assembly) detects panoramic moon roof switch (roof console box sub-assembly) is stuck for 30 seconds or more. | ·
Roof sunshade ECU (Sliding roof drive gear assembly) ·
Panoramic moon roof switch (Roof console box sub-assembly) ·
Wire harness or connector |
Refer to DTC B2341.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>B2341
If the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) must be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>INITIALIZATION
The panoramic moon roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication system. Refer to How to Proceed with Troubleshooting.
DTC B2342 is stored in the sliding roof ECU (sliding roof drive gear assembly) and roof sunshade ECU (sliding roof drive gear assembly).
Clear the DTCs.
Check for DTCs.
DTC B2342 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the parts from which this DTC has been output.
| Result | Proceed to |
|---|---|
| DTC output from sliding roof ECU (sliding roof drive gear assembly) | A |
| DTC output from roof sunshade ECU (sliding roof drive gear assembly) | B |
A
B
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Sliding Roof / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Current Roof Open Switch Stuck ON | Sliding roof open switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current)
ON: Sliding roof switch stuck signal (Current) |
- |
| Current Roof Close Switch Stuck ON | Sliding roof close switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current)
ON: Sliding roof switch stuck signal (Current) |
- |
| Current Shade Close Switch Stuck ON | Roof sunshade close switch stuck signal (Current) | OFF or ON | OFF: No roof sunshade switch stuck signal (Current)
ON: Roof sunshade switch stuck signal (Current) |
- |
| Current Shade Open Switch Stuck ON | Roof sunshade open switch stuck signal (Current) | OFF or ON | OFF: No roof sunshade switch stuck signal (Current)
ON: Roof sunshade switch stuck signal (Current) |
- |
| Past Roof Open Switch Stuck ON | Sliding roof open switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past)
ON: Sliding roof switch stuck signal (Past) |
- |
| Past Roof Close Switch Stuck ON | Sliding roof close switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past)
ON: Sliding roof switch stuck signal (Past) |
- |
| Past Shade Close Switch Stuck ON | Roof sunshade close switch stuck signal (Past) | OFF or ON | OFF: No roof sunshade switch stuck signal (Past)
ON: Roof sunshade switch stuck signal (Past) |
- |
| Past Shade Open Switch Stuck ON | Roof sunshade open switch stuck signal (Past) | OFF or ON | OFF: No roof sunshade switch stuck signal (Past)
ON: Roof sunshade switch stuck signal (Past) |
- |
| Current Vent Switch Stuck ON | Tilt switch stuck signal (Current) | OFF or ON | OFF: No tilt switch stuck signal (Current)
ON: Tilt switch stuck signal (Current) |
- |
| Past Vent Switch Stuck ON | Tilt switch stuck signal (Past) | OFF or ON | OFF: No tilt switch stuck signal (Past)
ON: Tilt switch stuck signal (Past) |
- |
| Tester Display |
|---|
| Current Roof Open Switch Stuck ON |
| Current Roof Close Switch Stuck ON |
| Current Shade Close Switch Stuck ON |
| Current Shade Open Switch Stuck ON |
| Past Roof Open Switch Stuck ON |
| Past Roof Close Switch Stuck ON |
| Past Shade Close Switch Stuck ON |
| Past Shade Open Switch Stuck ON |
| Current Vent Switch Stuck ON |
| Past Vent Switch Stuck ON |
OFF appears on the GTS screen.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the o1 sliding roof ECU (sliding roof drive gear assembly) connector.
Disconnect the V14 panoramic moon roof switch (roof console box sub-assembly) connector.
Disconnect the o2 roof sunshade ECU (sliding roof drive gear assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| o1-10 (ROOF OPEN) or V14-5 (OPN) - Body ground | Always | 10 kΩ or higher |
| o1-8 (ROOF CLOSE) or V14-4 (CLS) - Body ground | Always | 10 kΩ or higher |
| o1-4 (VENT) or V14-19 (B) - Body ground | Always | 10 kΩ or higher |
| o1-5 (SHADE OPEN) or V14-3 (UP) - Body ground | Always | 10 kΩ or higher |
| o1-9 (SHADE CLOSE) or V14-18 (DOWN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the panoramic moon roof switch (roof console box sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>REMOVAL
Inspect the panoramic moon roof switch (roof console box sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Sliding Sunshade / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Current Roof Open Switch Stuck ON | Sliding roof open switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current)
ON: Sliding roof switch stuck signal (Current) |
- |
| Current Roof Close Switch Stuck ON | Sliding roof close switch stuck signal (Current) | OFF or ON | OFF: No sliding roof switch stuck signal (Current)
ON: Sliding roof switch stuck signal (Current) |
- |
| Current Shade Close Switch Stuck ON | Roof sunshade close switch stuck signal (Current) | OFF or ON | OFF: No roof sunshade switch stuck signal (Current)
ON: Roof sunshade switch stuck signal (Current) |
- |
| Current Shade Open Switch Stuck ON | Roof sunshade open switch stuck signal (Current) | OFF or ON | OFF: No roof sunshade switch stuck signal (Current)
ON: Roof sunshade switch stuck signal (Current) |
- |
| Past Roof Open Switch Stuck ON | Sliding roof open switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past)
ON: Sliding roof switch stuck signal (Past) |
- |
| Past Roof Close Switch Stuck ON | Sliding roof close switch stuck signal (Past) | OFF or ON | OFF: No sliding roof switch stuck signal (Past)
ON: Sliding roof switch stuck signal (Past) |
- |
| Past Shade Close Switch Stuck ON | Roof sunshade close switch stuck signal (Past) | OFF or ON | OFF: No roof sunshade switch stuck signal (Past)
ON: Roof sunshade switch stuck signal (Past) |
- |
| Past Shade Open Switch Stuck ON | Roof sunshade open switch stuck signal (Past) | OFF or ON | OFF: No roof sunshade switch stuck signal (Past)
ON: Roof sunshade switch stuck signal (Past) |
- |
| Current Vent Switch Stuck ON | Tilt switch stuck signal (Current) | OFF or ON | OFF: No tilt switch stuck signal (Current)
ON: Tilt switch stuck signal (Current) |
- |
| Past Vent Switch Stuck ON | Tilt switch stuck signal (Past) | OFF or ON | OFF: No tilt switch stuck signal (Past)
ON: Tilt switch stuck signal (Past) |
- |
| Tester Display |
|---|
| Current Roof Open Switch Stuck ON |
| Current Roof Close Switch Stuck ON |
| Current Shade Close Switch Stuck ON |
| Current Shade Open Switch Stuck ON |
| Past Roof Open Switch Stuck ON |
| Past Roof Close Switch Stuck ON |
| Past Shade Close Switch Stuck ON |
| Past Shade Open Switch Stuck ON |
| Current Vent Switch Stuck ON |
| Past Vent Switch Stuck ON |
OFF appears on the GTS screen.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the o2 roof sunshade ECU (sliding roof drive gear assembly) connector.
Disconnect the V14 panoramic moon roof switch (roof console box sub-assembly) connector.
Disconnect the o1 sliding roof ECU (sliding roof drive gear assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| o2-10 (ROOF OPEN) or V14-5 (OPN) - Body ground | Always | 10 kΩ or higher |
| o2-8 (ROOF CLOSE) or V14-4 (CLS) - Body ground | Always | 10 kΩ or higher |
| o2-4 (VENT) or V14-19 (B) - Body ground | Always | 10 kΩ or higher |
| o2-5 (SHADE OPEN) or V14-3 (UP) - Body ground | Always | 10 kΩ or higher |
| o2-9 (SHADE CLOSE) or V14-18 (DOWN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the panoramic moon roof switch (roof console box sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>REMOVAL
Inspect the panoramic moon roof switch (roof console box sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG