Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU (for RHD) › 2017.09–2017.12
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0334376 CLEARANCE WARNING ECU(for RHD) A

PARK ASSIST / MONITORING  CLEARANCE WARNING ECU(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during clearance warning ECU assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ steering control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Replacement of clearance warning ECU assembly Adjust TOYOTA parking assist-sensor system TOYOTA parking assist-sensor system (Click here)

CAUTION:
B394719

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 73900 1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 55308B 2.REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY

HINT:

Use the same procedure as for LHD.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>REMOVAL


Hide 82877 3.REMOVE ECU INTEGRATION BOX RH

Hide 89340A 4.REMOVE CLEARANCE WARNING ECU ASSEMBLY

a.
E371187C02
1.781,3.167 1.698,2.74 true 1.698,3.167 2.01,3.323 0.313,0.156 10 false *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the clearance warning ECU assembly as shown in the illustration.

NOTICE:
·

If the ECU integration box is deformed or damaged, replace it.

·

Do not bend the claw more than necessary.