Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Front Door) › 2019.02–2021.02
RM33C0E _59 Vehicle Exterior _065474 EXTERIOR PANELS / TRIM _0333730 BLACK OUT TAPE(for Front Door) A

EXTERIOR PANELS / TRIM  BLACK OUT TAPE(for Front Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during black out tape removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Parking Support Brake System*
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
·

Front door glass sub-assembly

·

Front door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Catch protection function

·

Window open warning function


(Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 67492A 4.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 74038A 5.REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY

Hide 6.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 7.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Hide 74220 8.REMOVE FRONT ARMREST ASSEMBLY

Hide 81230 9.REMOVE COURTESY LIGHT ASSEMBLY

Hide 67602 10.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 11.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL

Hide 67832 12.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68102 13.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67856B 14.REMOVE FRONT DOOR PANEL PROTECTOR

Hide 68151C 15.REMOVE FRONT DOOR GLASS RUN

Hide 67862 16.DISCONNECT FRONT DOOR WEATHERSTRIP

Hide 67664C 17.REMOVE DOOR FRAME GARNISH

Hide 75976G 18.REMOVE FRONT DOOR NO. 2 STRIPE

HINT:

When removing the front door No. 2 stripe, heat the vehicle body and front door No. 2 stripe using a heat light.


Heating Temperature
Item Temperature
Front Door No. 2 Stripe and Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:
E306500C23
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the vehicle body excessively.


a.

Using a heat light, heat the front door No. 2 stripe and vehicle body.


b.
B469816

Pull back on one of the ends of the front door No. 2 stripe to remove it.

HINT:

When pulling on the front door No. 2 stripe, pull it parallel to the vehicle body.



Hide 75986B 19.REMOVE FRONT DOOR NO. 3 STRIPE

HINT:

When removing the front door No. 3 stripe, heat the vehicle body and front door No. 3 stripe using a heat light.


Heating Temperature
Item Temperature
Front Door No. 3 Stripe and Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:
E306500C23
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the vehicle body excessively.


a.

Using a heat light, heat the front door No. 3 stripe and vehicle body.


b.
B469817

Pull back on one of the ends of the front door No. 3 stripe to remove it.

HINT:

When pulling on the front door No. 3 stripe, pull it parallel to the vehicle body.