Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › FUSE BOX (for LITHIUM-ION BATTERY) › from 2020.08
RM33C0E _51 Engine / Hybrid System _065433 HYBRID / BATTERY CONTROL _0442445 FUSE BOX(for LITHIUM-ION BATTERY) A

HYBRID / BATTERY CONTROL  FUSE BOX(for LITHIUM-ION BATTERY)  INSTALLATION  


PROCEDURE

Hide G92Z2 1.INSTALL HYBRID BATTERY TERMINAL BLOCK

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Engage the claw to install the hybrid battery terminal block to the HV battery.


b.

Connect the hybrid battery terminal block connector.

NOTICE:

Make sure that the connector is connected securely.



Hide G92Z0 2.INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the HV battery junction block assembly to the HV battery with the 4 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:

If the HV battery junction block assembly has been struck or dropped, replace it with a new one.



b.

Connect the 2 HV battery junction block assembly connectors.

NOTICE:

Make sure that the connectors are connected securely.



c.

Install the electric vehicle battery plug assembly to the HV battery with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


d.

Connect the hybrid battery terminal block connector.

NOTICE:

Make sure that the connector is connected securely.



e.

Connect the HV battery junction block assembly connector.

NOTICE:

Make sure that the connector is connected securely.



f.

Engage the 2 claws to close the wiring harness protector.


Hide 71033 6.INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY

Hide 76974F 8.INSTALL REAR UNDER SIDE COVER LH

Hide 67918A 9.INSTALL REAR DOOR SCUFF PLATE LH

Hide 76973F 10.INSTALL REAR UNDER SIDE COVER RH

Hide 67917A 11.INSTALL REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.


Hide 72693 12.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 13.INSTALL REAR SEAT CUSHION ASSEMBLY

Hide 73350C 14.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Hide 16.PERFORM INITIALIZATION