Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV BATTERY STACK (for LITHIUM-ION BATTERY) › from 2020.08
RM33C0E _51 Engine / Hybrid System _065433 HYBRID / BATTERY CONTROL _0442447 HV BATTERY STACK(for LITHIUM-ION BATTERY) A

HYBRID / BATTERY CONTROL  HV BATTERY STACK(for LITHIUM-ION BATTERY)  INSTALLATION  


PROCEDURE

Hide G9509 1.INSTALL NO. 2 HV SUPPLY STACK SUB-ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the No. 2 HV supply stack sub-assembly with the 4 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.

Engage the claw.


c.

Engage the clamp.


d.

Install the nut to connect the earth terminal.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide G9508 2.INSTALL NO. 1 HV SUPPLY STACK SUB-ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the No. 1 HV supply stack sub-assembly with the 4 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.

Engage the claw.


c.

Connect the connector.

NOTICE:

Make sure that the connector is connected securely.



d.

Connect the connector.

NOTICE:

Make sure that the connector is connected securely.



Hide G92E1A 4.INSTALL NO. 1 HV BATTERY INTAKE DUCT LH

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the No. 1 HV battery intake duct LH to the HV battery with the clip.


b.

Engage the claw of hybrid battery thermistor (sensor portion) to connect the No. 1 HV battery intake duct LH.


Hide G920R 5.INSTALL NO. 2 HYBRID BATTERY SHIELD SUB-ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the No. 2 hybrid battery shield sub-assembly to the HV battery with the bolt and 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 11.PERFORM INITIALIZATION