The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
1.DRAIN ENGINE COOLANT (for Engine)
53295E
2.REMOVE COOL AIR INTAKE DUCT SEAL (w/ Canister Pump Module)
17750A
3.REMOVE INLET AIR CLEANER ASSEMBLY (w/ Canister Pump Module)
89422
4.REMOVE NO. 2 ENGINE COOLANT TEMPERATURE SENSOR (w/ Canister Pump Module)
Disconnect the No. 2 engine coolant temperature sensor connector.
Remove the clip and No. 2 engine coolant temperature sensor from the radiator pipe.
If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.
G9200
5.REMOVE INVERTER WITH CONVERTER ASSEMBLY
89422A
6.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Disconnect the engine coolant temperature sensor connector.
Remove the clip and engine coolant temperature sensor from the water outlet.
If the engine coolant temperature sensor has been struck or dropped, replace it.