Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TELEVISION CAMERA (for Front) › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0461973 TELEVISION CAMERA(for Front) A

PARK ASSIST / MONITORING  TELEVISION CAMERA(for Front)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front television camera assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Applies only for when removing and installing or replacing the rear television camera assembly.

Front television camera assembly Front television camera view adjustment Panoramic view monitor system (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

·

Rear television camera assembly optical axis (Back camera position setting)*1



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 86790B 2.REMOVE FRONT TELEVISION CAMERA ASSEMBLY (for Bar Type Radiator Grille)

a.
E459809

Disconnect the connector.


b.
E459810

Remove the 2 screws.


c.

Disengage the 2 guides to remove the front television camera assembly.


Hide 3.REMOVE FRONT BUMPER COVER INSERT (for Mesh Type Radiator Grille)

Hide 86790B 4.REMOVE FRONT TELEVISION CAMERA ASSEMBLY (for Mesh Type Radiator Grille)

a.
E459812

Disconnect the connector.


b.
E459813

Remove the 3 screws.


c.

Disengage the 2 guides to remove the front television camera assembly.