If the telematics transceiver detects an error in the communication between the telematics transceiver and the roof console box sub-assembly (manual (SOS) switch) as a result of the telematics transceiver self check, this DTC will be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C511 | Emergency Call Switch Circuit Short to Ground | Manual (SOS) switch impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON | ·
Roof console box sub-assembly (manual (SOS) switch) ·
Harness or connector ·
Telematics transceiver |
| B15C513 | Emergency Call Switch Circuit Open | Manual (SOS) switch impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON | ·
Roof console box sub-assembly (manual (SOS) switch) ·
Harness or connector ·
Telematics transceiver |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>PRECAUTION
When replacing the telematics transceiver, make sure to replace it with a new one.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and wait for 10 seconds or more.
Turn the GTS on.
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTCs are output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
| *a | Component without harness connected
(Roof Console Box Sub-assembly (Manual (SOS) Switch)) |
Remove the roof console box sub-assembly (manual (SOS) switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 17 (SIG1) - 12 (GND3) | Manual (SOS) switch not operated | 410 to 414 Ω |
| 17 (SIG1) - 12 (GND3) | Manual (SOS) switch operated | 81 to 83 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K151 telematics transceiver connector.
Disconnect the V18 roof console box sub-assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K151-21 (SIG1) - V18-17 (SIG1) | Always | Below 1 Ω |
| K151-3 (SIG-) - V18-12 (GND3) | Always | Below 1 Ω |
| K151-21 (SIG1) or V18-17 (SIG1) - Body ground | Always | 10 kΩ or higher |
| K151-3 (SIG-) or V18-12 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telematics transceiver with a new one.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT