Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › from 2021.02
RM33C0E _51 Engine / Hybrid System _065419 A25A-FXS ENGINE CONTROL _0326950 ENGINE COOLANT TEMPERATURE SENSOR A

A25A-FXS ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Replacement of inverter with converter assembly Resolver learning
·

DTCs are stored

·

Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

·

Shock or vibration during acceleration


(Click here)for Nickel Metal Hydride Battery
(Click here)for Lithium-ion Battery
Replacement of ECM Vehicle Identification Number (VIN) or frame number registration MIL illuminates (Click here)(w/ Canister Pump Module)
(Click here)(w/o Canister Pump Module)
Replacement of engine coolant temperature sensor Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)(w/ Canister Pump Module)
(Click here)(w/o Canister Pump Module)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT (for Engine)

Hide 53295E 2.REMOVE COOL AIR INTAKE DUCT SEAL (w/ Canister Pump Module)

Hide 17750A 3.REMOVE INLET AIR CLEANER ASSEMBLY (w/ Canister Pump Module)

Hide 89422 4.REMOVE NO. 2 ENGINE COOLANT TEMPERATURE SENSOR (w/ Canister Pump Module)

a.
A406043

Disconnect the No. 2 engine coolant temperature sensor connector.


b.
A406044

Remove the clip and No. 2 engine coolant temperature sensor from the radiator pipe.

NOTICE:

If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.



Hide G9200 5.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide 89422A 6.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A406041

Disconnect the engine coolant temperature sensor connector.


b.
A406042

Remove the clip and engine coolant temperature sensor from the water outlet.

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.