The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front stabilizer bar removal/installation are shown below.
1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
48810
2.REMOVE FRONT STABILIZER LINK ASSEMBLY LH
Remove the cap from the nut.
Remove the nut and front stabilizer link assembly LH from the front stabilizer bar.
Do not damage the boot of the ball joint.
If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.
48820B
3.REMOVE FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
48829A
4.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
Remove the 2 bolts and front No. 1 stabilizer bracket LH from the front frame assembly.
48824A
5.REMOVE FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as for the LH side.
48811
6.REMOVE FRONT STABILIZER BAR
Remove the front stabilizer bar with 2 front stabilizer bar bushings from the front frame assembly.
48815
7.REMOVE FRONT NO. 1 STABILIZER BAR BUSHING (for LH Side)
Remove the front No. 1 stabilizer bar bushing from the front stabilizer bar.
48815
8.REMOVE FRONT NO. 1 STABILIZER BAR BUSHING (for RH Side)
Perform the same procedure as for the LH side.