Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH › from 2021.02
RM33C0E _59 Vehicle Exterior _065471 WIPER / WASHER _0332912 WASHER LEVEL WARNING SWITCH A

WIPER / WASHER  WASHER LEVEL WARNING SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during level warning switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*1: Applies only for when removing and installing or replacing the rear television camera assembly.

Front bumper assembly (w/ Panoramic View Monitor System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)for Initialization
(Click here)for Calibration
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

·

Rear television camera assembly optical axis (Back camera position setting)*1



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 85397 3.REMOVE LEVEL WARNING SWITCH ASSEMBLY

a.
E364831C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Remove the level warning switch assembly as shown in the illustration.