Home › Engine / Hybrid System › N04C-UH (ENGINE CONTROL) › ECD SYSTEM
RM2850E _51 Engine / Hybrid System _073137 N04C-UH ENGINE CONTROL _0355844 ECD SYSTEM C

N04C-UH ENGINE CONTROL  ECD SYSTEM  P2226  Barometric Pressure Circuit  P2227  Barometric Pressure Circuit Range / Performance  P2228  Barometric Pressure Circuit Low Input  P2229  Barometric Pressure Circuit High Input  


DESCRIPTION

The atmospheric pressure sensor, built into the ECM, detects the atmospheric pressure. According to the value of the atmospheric pressure, the ECM corrects the injection timing, the injection volume and the amount of common rail internal fuel pressure for an optimum combustion.

DTC No. DTC Detection Condition Trouble Area
P2226 Open or short in atmospheric pressure sensor circuit for more than 0.5 seconds (ECM internal malfunction)
(1 trip detection logic)
ECM
P2227 Atmospheric pressure sensor malfunction (The MIL is illuminated as well as a DTC being set immediately malfunction is detected)
(2 trip detection logic)
ECM
P2228 Short in atmospheric pressure sensor circuit for more than 0.5 seconds (ECM internal malfunction)
(1 trip detection logic)
ECM
P2229 Open in atmospheric pressure sensor circuit for more than 0.5 seconds (ECM internal malfunction)
(1 trip detection logic)
ECM

HINT:

DTC P2227 is stored when the ignition switch is turned to ON.


CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).


PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P2226, P2227, P2228 AND P2229)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.


e.

Read the DTCs.


Result:
Result Proceed to
P2226, P2227, P2228 or P2229 and other DTCs A
P2226, P2227, P2228 or P2229 B



A

B