Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
83210
1.INSTALL TACHOGRAPH ASSEMBLY
Install the tachograph assembly with the 4 screws.
55601C
2.INSTALL INSTRUMENT PANEL UNDER TRAY SUB-ASSEMBLY
55470
3.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
55412D
4.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL
86250
5.INSTALL AMPLIFIER MICROPHONE ASSEMBLY (w/ Microphone)
55433B
6.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
58841A
7.INSTALL SHIFTING HOLE COVER (for Automatic Transmission)
58848A
8.INSTALL SHIFT LEVER HOLE COVER (for Manual Transmission)
58286
9.INSTALL NO. 1 SHIFT AND SELECT LEVER BOOT (for Manual Transmission)
58534A
10.INSTALL TRANSMISSION COVER MAT (for Manual Transmission)
Install the transmission cover mat to the shift and select lever support.
33504F
11.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)
Gently rotate the shift lever knob sub-assembly by hand until it locks.
After locking, further tighten by 1.5 turns.
After tightening, rotate and adjust the tightened direction so that the shift pattern is positioned within +/-10° of the front of the vehicle.