Home › Engine / Hybrid System › N04C-VQ (COOLING) › THERMOSTAT › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073147 N04C-VQ COOLING _0355930 THERMOSTAT A

N04C-VQ COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.
A398629E02
2.208,1.667 1.938,1.365 true 2.281,1.594 3.24,1.76 0.958,0.167 10 false 2.2 to 2.7 mm

Apply a continuous bead of seal packing (diameter 2.2 to 2.7 mm (0.0866 to 0.1063 in.)) as shown in the illustration.

Seal packing:

Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent.


NOTICE:
·

Remove any oil from the contact surface.

·

Install the water outlet within 3 minutes of applying the seal packing.

·

Do not start the engine for at least 2 hours after the installation.




b.

Install a new gasket onto the thermostat.


c.
A147510E04
1,0.385 1.302,0.385 1.302,0.385 1.698,0.813 false 0.802,0.302 1,0.5 0.198,0.198 10 false *a

Align the jiggle valve to the position shown in the illustration and install the thermostat.

Text in Illustration
*a Jiggle Valve


d.

Install the water outlet with the 3 bolts.

Torque:

29 N*m (291 kgf*cm, 21 ft.*lbf)



Hide 16571 2.CONNECT INLET RADIATOR HOSE

Hide 17341K 4.CONNECT NO. 1 INTERCOOLER AIR HOSE

Hide 16206 5.CONNECT WATER BY-PASS PIPE SUB-ASSEMBLY

a.

Connect the water by-pass pipe sub-assembly with the 3 bolts

Torque:

29 N*m (291 kgf*cm, 21 ft.*lbf)



b.

Connect the water by-pass hose and slide the hose clamp to secure the hose.


Hide 58701A 8.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 33506F 9.INSTALL FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY

Hide 58123A 10.INSTALL SHIFT AND SELECT LEVER SUPPORT WITH BOOTS

Hide 58420 11.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58734B 12.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58410 13.INSTALL ENGINE SERVICE HOLE COVER

Hide 58521D 14.INSTALL ENGINE SERVICE HOLE COVER MAT