17111
1.INSTALL INTAKE MANIFOLD
Apply seal packing to the areas shown in the illustration.
Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
2.2 mm (0.0866 in.)
| *a | Seal Packing |
Remove any oil from the contact surface.
Install the intake manifold within 3 minutes after applying seal packing.
Do not start the engine for at least 2 hours after installation.
Install the intake manifold with the 8 bolts and 2 nuts.
29 N*m (291 kgf*cm, 21 ft.*lbf)
Install the wiring harness bracket sub-assembly with the 2 bolts.
29 N*m (291 kgf*cm, 21 ft.*lbf)
Attach the wire harness clamp and install the 2 bolts.
18 N*m (179 kgf*cm, 13 ft.*lbf)
17113
2.INSTALL INTAKE PIPE
Install the intake pipe with the 3 bolts and 2 nuts.
29 N*m (291 kgf*cm, 21 ft.*lbf)
89424G
3.INSTALL INTAKE AIR TEMPERATURE SENSOR
23810A
4.INSTALL COMMON RAIL ASSEMBLY
25620
5.INSTALL EGR VALVE ASSEMBLY
26100
6.INSTALL DIESEL THROTTLE BODY ASSEMBLY