Home › Engine / Hybrid System › 1HZ FUEL › FUEL INJECTION PUMP
RM2850E _51 Engine / Hybrid System _073151 1HZ FUEL _0355954 FUEL INJECTION PUMP A

1HZ FUEL  FUEL INJECTION PUMP  INSTALLATION  


PROCEDURE

Hide 22100 1.INSTALL INJECTION PUMP

NOTICE:

Do not put the injection pump (with HAC, or for the 1 HD-T) at an angle more than 45° from the horizontal.


a.

(1PZ and 1HZ (M/T for Europe))

Place the cylinder block insulator in position.


b.
A423032

Install a new O-ring to the pump.


c.

Apply a light coat of engine oil on the O-ring.


d.
A423033

Align the set key on the drive shaft and groove of the injection pump drive gear.


e.
A423034

Align the period lines (or matchmarks) of the injection pump and timing belt case.


f.

Install the two nuts holding the injection pump to the timing gear case.

Torque:

185 kg*cm (13 ft*lb, 18 N*m)



g.
A423035

A423036

Install the pump stay mount bolt.

Torque:

700 kg*cm (51 ft*lb, 69 N*m)


NOTICE:

Before tightening to the standard torque, check whether the pumpstay is up against the pump braket.


If there is a gap, loosen the bolts joining the pump stay to the cylinder block and set the pump stay against the pump bracket.


h.
A423037

Install a new O-ring to the injection pump drive gear.


i.

Install the injection pump drive gear set nut.


j.
A423038

Using SST, torque the nut.

SST
09330-00021  

Torque:

1,000 kg*cm (72 ft*lb, 98 N*m)



Hide 3.INSTALL INJECTION PIPES

Click hereEngine / Hybrid System>1HZ FUEL>INJECTION NOZZLES>INJECTION NOZZLES INSTALLATION

Torque:

1PZ and 1HZ 150 kg*cm (11 ft*lb, 15 N*m)

1HD-T 250 kg*cm (18 ft*lb, 25 N*m)


Hide 4.CONNECT BAGS VACUUM HOSE (w/ BAGS)

Hide 5.CONNECT PCS VACUUM HOSE (w/ PCS)

Hide 6.CONNECT BOOST COMPENSATOR HOSE (1HD-T)

Hide 7.CONNECT FUEL HOSES TO INJECTION PUMP

Hide 8.CONNECT INJECTION PUMP CONNECTOR

Hide 9.CONNECT WATER BY-PASS HOSES TO THERMO WAX (w/ ACSD)

Hide 10.CONNECT A/C IDLE-UP VACUUM HOSE (w/ A/C)

Hide 11.CONNECT THROTTLE CABLE (A/T)

Hide 78104 12.CONNECT ACCELERATOR CONNECTING ROD

Hide 13523P 13.INSTALL NO.2 CAMSHAFT TIMING PULLEY