16100
1.INSTALL WATER PUMP
Install a new gasket, the water pump and No.2 turbo water pipe (1HD-T) with the five bolts and two nuts.
200 kg*cm (14 ft*lb, 20 N*m)
Install the alternator adjusting bar with the two bolts (A).
400 kg*cm (29 ft*lb, 39 N*m)
Temporarily install the lock bolt (B).
(1HD-T)
Connect the water by-pass hoses.
11385
2.INSTALL CAMSHAFT OIL SEAL RETAINER
13523P
3.INSTALL NO.1 CAMSHAFT TIMING PULLEY
4.INSTALL IDLER PULLEY TIMING BELT
5.INSTALL WATER PUMP PULLEY, FAN AND DRIVE BELT
Install the pump pulley, the fluid fan and coupling (fan spacer) assembly with the four nuts.
Place the drive belt on each pulley.
Stretch the belt tight and torque the four nuts.
200 kg*cm (14 ft*lb, 20 N*m)
Adjust the drive belt deflection.
Click hereEngine / Hybrid System>1HZ (ENGINE MECHANICAL)>ENGINE TUNE-UP>ALTERNATOR DRIVE BELT INSPECTION
6.FILL WITH ENGINE COOLANT
7.START ENGINE AND CHECK FOR LEAKS