Home › Engine / Hybrid System › N04C-VL (FUEL) › COMMON RAIL
RM2850E _51 Engine / Hybrid System _073161 N04C-VL FUEL _0356009 COMMON RAIL A

N04C-VL FUEL  COMMON RAIL  REMOVAL  


PROCEDURE

Hide 58410 1.REMOVE ENGINE SERVICE HOLE COVER

Hide 58734B 2.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58521D 3.REMOVE ENGINE SERVICE HOLE COVER MAT

Hide 58420 4.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 33504F 5.REMOVE SHIFT KNOB

Hide 58534A 6.REMOVE TRANSMISSION COVER MAT

Hide 58286 7.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT

Hide 33820B 8.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 33503F 9.REMOVE FLOOR SHIFT SHIFT LEVER SUB-ASSEMBLY

Hide 58701A 10.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 51441D 11.REMOVE NO. 1 ENGINE UNDER COVER

Hide 53712C 12.REMOVE FRONT FENDER APRON LH

Hide 44360 14.SEPARATE VANE PUMP OIL RESERVOIR ASSEMBLY

a.
A146546

Remove the 3 bolts and separate the vane pump oil reservoir assembly.


Hide 11409 16.REMOVE OIL LEVEL GAUGE GUIDE SUB-ASSEMBLY

a.
A146475

Remove the bolt and the oil level gauge guide sub-assembly.


b.

Remove the O-ring from the oil level gauge guide sub-assembly.


Hide 17.REMOVE INTAKE PIPE WITH DIESEL THROTTLE BODY

a.
A146653

Disconnect the throttle control motor connector and throttle position sensor connector.


b.

Disconnect the vacuum hose from the intake pipe.


c.
A345056

Remove the 2 nuts, the 2 bolts and the intake pipe with diesel throttle body.

Text in Illustration
V100135

Bolt
V100136

Nut


Hide 17113 18.REMOVE INTAKE PIPE

a.
A345060

Remove the wire harness clamp.


b.

Remove the 6 bolts and the intake pipe.


Hide 19.REMOVE NO. 2 HARNESS BRACKET

a.
A345059

Disengage the 3 harness clamps.


b.

Remove the 2 bolts and No. 2 harness bracket.


Hide 23741B 20.REMOVE INJECTION PIPE CLAMP

a.
A157024

Remove the 2 nuts and 2 injection pipe clamps.


Hide 21.REMOVE INJECTION PIPE SUB-ASSEMBLY

a.
A154205

Using a union nut wrench (17 mm), loosen the 8 union nuts and remove the injection pipe sub-assembly.

NOTICE:

Be sure to prevent foreign matter or water from entering the lines.



Hide 23811 22.REMOVE FUEL FILTER TO INJECTION PUMP FUEL PIPE

a.
A180215

Remove the nut and the fuel pipe clamp.


b.

Using a union nut wrench (17 mm), loosen the 2 union nuts and remove the fuel filter to injection pump fuel pipe.

NOTICE:

Be sure to prevent foreign matter or water from entering the lines.



Hide 23810A 23.REMOVE COMMON RAIL ASSEMBLY

a.
A157327

Disconnect the fuel pressure sensor connector.


b.

Loosen the clip and separate the fuel hose.


c.

Remove the 2 bolts and the common rail assembly.

NOTICE:

Be sure to prevent foreign matter or water from entering the lines.