Home › Engine / Hybrid System › 14B (LUBRICATION) › OIL PUMP › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073172 14B LUBRICATION _0356062 OIL PUMP A

14B LUBRICATION  OIL PUMP  OIL PUMP REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When repairing the oil pump, the oil pan and strainer should be removed and cleaned.


PROCEDURE

Hide 1. SET N0.1 CYLINDER TO TDC/COMPRESSION

Hide 2.DRAIN ENGINE OIL

Hide 3.REMOVE DRIVE BELT(S), FAN, FLUID COUPLING ASSEMBLY (FAN AND FAN SPACER) AND WATER PUMP PULLEY

Hide 23600 5.REMOVE INJECTION NOZZLES (14B, 15B-F, 15B-FT)

Hide 13901 6.REMOVE VALVE ROCKER SHAFT SUB-ASSEMBLY

Hide 8.REMOVE VACUUM PUMP AND IDLE GEAR AND CRANKSHAFT TIMING GEAR

Hide 13523 9.REMOVE CAMSHAFT TIMING GEAR

a.
A424260

Using SST, remove the mount bolt and plate washer.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A424261

Using SST, remove the timing gear.

SST
09950-40011  (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051)


Hide 10.REMOVE OIL DIPSTICK AND GUIDE (BB)

a.

Remove the 2 bolts, and pull out the dipstick guide together with the dipstick from the oil pan.


b.

Remove the O-ring from the dipstick guide.


Hide 89491 11.REMOVE OIL LEVEL SENSOR

a.

Remove the 4 bolts, oil level sensor and gasket,


Hide 12101 12.REMOVE OIL PAN

a.

Remove the 17 bolts and 7 nuts.


b.
A424262

Insert the blade of an oil pan seal cutter between the cylinder block and oil pan, and cut off applied sealer and remove the oil pan.

NOTICE:
·

Do not use oil pan seal cutter for the timing gear case side and rear oil seal retainer side.

·

Be careful not to damage the oil pen flange.




Hide 13.REMOVE OIL STRAINER AND OIL PIPE

a.
A424263

Remove the 2 bolts (BU), 2 nuts, oil strainer and gasket.


b.

Remove the union bolt, 2 nuts, oil pipe and 3 gasket.


Hide 14.REMOVE VACUUM PIPE (15B-F, 15B-FT)

a.
A424264

Disconnect these vacuum hoses.

·

Vacuum hose from 3-way connector

·

Vacuum hose from vacuum pump



b.

Remove the bolt (15B-F) or 2 bolts (15B-FT) and vacuum pipe.


Hide 11301 15.REMOVE OIL PUMP (TIMING GEAR CASE)

HINT:

Before removing the 2 nuts holding the injection pump flange to the timing gear case, check if the matchmarks are aligned. If not, place new matchmarks for reinstallation.


a.
A424265

Remove the 2 nuts holding the injection pump to the timing gear case.


b.
A424266

Remove the 8 bolts holding the timing gear case to the cylinder block.


c.
A424267

Using a plastic-faced hammer, lightly tap out the timing gear case and gasket.