Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
1.REMOVE REAR SEAT ASSEMBLY (for Rear End)
for Tumble Type 4-Passenger Seat:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Tumble Type 4-Passenger Seat)>REMOVAL
for Fixed Type 4-Passenger Seat:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fixed Type 4-Passenger Seat)>REMOVAL
2.REMOVE ROOF HEADLINING
3.REMOVE SIDE PANEL
for RHD:
Perform the linked removal procedures until the No. 1 side trim assembly RH.
Click hereVehicle Interior>INTERIOR>SIDE PANEL (for RHD)>REMOVAL
for LHD:
Perform the linked removal procedures until the No. 1 side trim assembly LH.
Click hereVehicle Interior>INTERIOR>SIDE PANEL (for LHD)>REMOVAL
75505
4.REMOVE FRONT ROOF SIDE GARNISH SUB-ASSEMBLY RH
5.REMOVE REAR SIDE FRONT WINDOW GLASS RH
The rear side front window glass may fall while performing this procedure. Therefore, use suction cups to hold the rear side front window glass from the outside of the vehicle.
Apply protective tape to the outer surface of the vehicle body and glass to prevent scratches.
| *1 | Protective Tape |
Install the suction cups to the rear side front window glass RH.
Apply a sufficient amount of soapy water to the adhesive.
Start this procedure where the rear side front window glass RH and body are furthest apart.
From the interior, insert a knife between the vehicle body and glass.
Cut through the adhesive by knife around the glass.
Using suction cups, disconnect the 4 side window glass spacers and remove the rear side front window glass RH.
Be careful not to drop the rear side front window glass RH.