The skid control ECU (brake actuator assembly) outputs this DTC when it receives an internal malfunction signal from the steering angle sensor.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1433 | With the +BS terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor. | Steering angle sensor (Spiral with sensor cable subassembly) |
Refer to DTC C1432 (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>C1432).
When U0073, U0124 and/or U0126 is output together with C1433, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>U0073).
When any of the speed sensors or the yaw rate and acceleration sensor (yaw rate sensor)*1 or yaw rate and acceleration sensor (airbag ECU assembly)*2 has trouble, DTCs for the steering angle sensor (spiral with sensor cable subassembly) may be output even when the steering angle sensor (spiral with sensor cable sub-assembly) is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor (yaw rate sensor)*1 or yaw rate and acceleration sensor (airbag ECU assembly)*2 are output together with DTCs for the steering angle sensor (spiral with sensor cable sub-assembly), inspect and repair the speed sensor and yaw rate and acceleration sensor (yaw rate sensor)*1 or yaw rate and acceleration sensor (airbag ECU assembly)*2 first, and then inspect and repair the steering angle sensor (spiral with sensor cable sub-assembly).
*1: w/o Airbag System
*2: w/ Airbag System
Replace the spiral with sensor cable sub-assembly (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR (w/ Brake pedal Load Sensing Switch)>REMOVAL).
Do not remove the steering angle sensor from the spiral with sensor cable subassembly.
When replacing the spiral with sensor cable sub-assembly, confirm that the replacement part is of the correct specification.
| Proceed to |
|---|
| NEXT |
NEXT