Home › Engine / Hybrid System › 2TR-FE COOLING › THERMOSTAT
RM2850E _51 Engine / Hybrid System _073291 2TR-FE COOLING _0356995 THERMOSTAT A

2TR-FE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.
A431310E01
1.948,1.115 1.188,0.385 1.188,0.385 1.104,0.385 false 1.688,0.385 2.438,0.594 0.75,0.208 10 false CORRECT 2.458,1.385 3.313,1.625 0.854,0.24 10 false INCORRECT 0.594,0.292 1.104,0.479 0.51,0.188 10 false Gasket 2.542,1.823 3.104,2.021 0.563,0.198 10 false Upward 2.76,3.073 3.188,3.281 0.427,0.208 10 false : 10°

Install a new gasket onto the thermostat.

HINT:

When installing the thermostat into the gasket, be careful not to deform the gasket. Make sure that the thermostat is properly installed into the groove of the gasket, as shown in the illustration.



b.

Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.

HINT:

The jiggle valve may be set within 10° of either side of the prescribed position.



Hide 16321 2.INSTALL WATER INLET

a.
A180033

Install the water inlet with the 2 nuts and bolt.

Torque:

28 N*m (286 kgf*cm, 21 ft.*lbf)



Hide 16572D 3.CONNECT NO. 2 RADIATOR HOSE

a.
A178419E01
0.909,2.107 1.23,2.246 0.32,0.139 10 UPR

Connect the No. 2 radiator hose with the clip.


Hide 44310 4.INSTALL VANE PUMP ASSEMBLY

a.
C158310

Install the vane pump assembly with the 2 bolts.

Torque:

21 N*m (214 kgf*cm, 16 ft.*lbf)



Hide 16361A 5.INSTALL FAN AND GENERATOR V BELT

Hide 88310A 6.INSTALL NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT

Hide 58701A 7.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 33506F 8.INSTALL FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:

3.9 N*m (40 kgf*cm, 35 in.*lbf)


Hide 58123A 12.INSTALL SHIFT AND SELECT LEVER SUPPORT WITH BOOTS

Hide 58420 13.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58521D 14.INSTALL ENGINE SERVICE HOLE COVER MAT

Hide 58734B 15.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58410 16.INSTALL ENGINE SERVICE HOLE COVER

Hide 51405A 17.INSTALL NO. 1 ENGINE UNDER COVER