1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
58410
3.REMOVE ENGINE SERVICE HOLE COVER
58734B
4.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP
58521D
5.REMOVE ENGINE SERVICE HOLE COVER MAT
58420
6.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58123A
7.REMOVE SHIFT AND SELECT LEVER SUPPORT WITH BOOTS
33506F
8.REMOVE FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY
58701A
9.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
16701
10.REMOVE FAN SHROUD SUB-ASSEMBLY
17113D
11.REMOVE NO. 1 INTAKE PIPE
27020
12.REMOVE GENERATOR ASSEMBLY
Remove the terminal cap.
Detach the clamps.
| *a | Terminal Cap |
| *b | Clamp |
Remove the nut and disconnect the terminal B.
Disconnect the connector.
Remove the 2 bolts and disconnect the wire harnesses from the generator bracket.
| *a | Nut |
| *b | Connector |
| *c | Bolt |
Remove the 3 bolts and the generator bracket.
| *1 | Generator Bracket |
Remove the bolt and the generator assembly.