A thermistor is built into the engine coolant temperature sensor and changes its resistance value according to the engine coolant temperature.
The structure of the sensor and connection to the ECM is the same as the intake air temperature sensor.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0115 | Open or short in engine coolant temperature sensor circuit for 0.5 seconds | ·
Open or short in engine coolant temperature sensor circuit ·
Engine coolant temperature sensor ·
ECM |
| P0117 | Short in engine coolant temperature sensor circuit for 0.5 seconds | ·
Short in engine coolant temperature sensor circuit ·
Engine coolant temperature sensor ·
ECM |
| P0118 | Open in engine coolant temperature sensor circuit for 0.5 seconds | ·
Open in engine coolant temperature sensor circuit ·
Engine coolant temperature sensor ·
ECM |
When DTC P0115, P0117 and/or P0118 are detected, check the engine coolant temperature by entering the following menus on the GTS: Powertrain / Engine and ECT / Data List / Coolant Temp.
| Temperature Displayed | Malfunction |
|---|---|
| -40°C (-40°F) | Open circuit |
| 140°C (284°F) | Short circuit |
After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
If DTCs that are related to different systems are output simultaneously while terminal E2 is used as a ground terminal, terminal E2 may have an open circuit.
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
| Temperature Display | Proceed to |
|---|---|
| -40°C (-40°F) | A |
| 140°C (284°F) | B |
| OK (same as the actual engine coolant temperature) | C |
If there is an open circuit, the GTS indicates -40°C (-40°F).
If there is a short circuit, the GTS indicates 140°C (284°F).
A
B
C
Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>CHECK FOR INTERMITTENT PROBLEMS
Disconnect the engine coolant temperature sensor connector.
Connect terminals 1 (THW) and 2 (E2) of the engine coolant temperature sensor wire harness side connector.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
Read the value.
140°C (284°F)
| *a | Front view of wire harness connector
(to Engine Coolant Temperature Sensor) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the engine coolant temperature sensor connector.
Connect terminals THW and E2 of the ECM connector.
Before checking, perform a visual and contact pressure check for the ECM connector.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
Read the value.
140°C (284°F)
| *a | Component with harness connected
(ECM) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the engine coolant temperature sensor connector.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
Read the value.
-40°C (-40°F)
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the engine coolant temperature sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the valve(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B105-9 (THW) or k1-1 (THW) - Body ground | Always | 10 kΩ or higher |
| B104-14 (E2) or k1-2 (E2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG