Home › Engine / Hybrid System › N04C-VL (ENGINE CONTROL) › ECD SYSTEM
RM2850E _51 Engine / Hybrid System _073159 N04C-VL ENGINE CONTROL _0357053 ECD SYSTEM C

N04C-VL ENGINE CONTROL  ECD SYSTEM  P062F  Internal Control Module EEPROM Error  


DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
P062F Either condition below is met (1 trip detection logic):
·

Injector compensation code is not registered.

·

Incorrect injector compensation code is registered.


·

Injector compensation code

·

ECM



NOTICE:
·

When an injector assembly is replaced, the injector compensation code must be input into the ECM.

·

When the ECM is replaced, all of the existing injector compensation codes must be input into the new ECM.

·

Injector compensation codes are unique, 30-digit, alphanumeric values printed on the head portion of each injector. If an incorrect injector compensation code is input into the ECM, the engine assembly may rattle or engine idling may become rough. In addition, engine failure may occur and the life of the engine may be shortened.



When replacing the ECM with a new one, input all the injector compensation codes into the new ECM as follows:


a.

Prior to replacing the ECM, use the GTS to read and save each injector compensation code from the original ECM.


b.

After installing a new ECM, input the saved compensation codes into the new ECM using the GTS.


c.

Turn the ignition switch off and then turn the GTS off.


d.

Wait for at least 30 seconds.


e.

Turn the ignition switch to ON and then turn the GTS on.


f.

Clear DTC P062F stored in the ECM using the GTS (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>DTC CHECK / CLEAR).

HINT:
·

Each injector assembly has different fuel injection characteristics. In order to optimize the fuel injections, the ECM uses the compensation codes to balance the different fuel injections between each injector assembly.

·

When first turning the ignition switch to ON after replacing the ECM or an injector(s), DTC P062F is stored. If an injector was replaced, the compensation code for the new injector will need to be registered in the ECM. If the ECM was replaced, the compensation codes for the injector assembly must be registered to the new ECM. Manually clear the DTCs upon completion of compensation code registration.





CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).


HINT:

Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.


PROCEDURE

1.CHECK INJECTOR COMPENSATION CODE
a.

Read the injector compensation code (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION).

OK:

Compensation codes stored in the ECM match compensation codes of the installed injector assemblies.



Result:
Proceed to
OK
NG



OK

NG

PERFORM REGISTRATION OF INJECTOR COMPENSATION CODES