| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0850 | No exhaust brake neutral switch signals to ECM despite vehicle driving with varying vehicle speed between 0 and 80 km/h:
(1 trip detection logic) |
·
Open or short in exhaust brake neutral switch circuit ·
Exhaust brake neutral switch assembly ·
ECM |
After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.
Inspect the exhaust brake neutral switch assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the exhaust brake neutral switch assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B25-1 (NSW+) - B103-21 (NUSW) | Always | Below 1 Ω |
| B25-1 (NSW+) or B103-21 (NUSW) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the exhaust brake neutral switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B25-2 (NSW-) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG