The front airbag sensor consists of a diagnostic circuit, frontal deceleration sensor, etc.
If the airbag ECU assembly receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.
DTC B161B/1A is stored when a malfunction is detected in the front airbag sensor circuit.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B161B/1A | Either condition is met:
·
A front airbag sensor malfunction. ·
An airbag ECU assembly malfunction. |
·
Front airbag sensor ·
Airbag ECU assembly |
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
After replacing the airbag ECU assembly, refer to initialization (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
To perform the simulation method, wiggle each connector of the airbag system or drive the vehicle on various types of roads (Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>DIAGNOSIS SYSTEM).
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait at least 90 seconds.
Temporarily replace the front airbag sensor with a new one (Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>FRONT AIRBAG SENSOR>REMOVAL).
Connect the cable to the negative (-) battery terminal, and wait at least 2 seconds.
Turn the ignition switch to ON, and wait at least 60 seconds.
Clear the DTCs stored in memory (Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>DTC CHECK / CLEAR).
Turn the ignition switch off.
Turn the ignition switch to ON, and wait at least 60 seconds.
Check for DTCs (Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>DTC CHECK / CLEAR).
DTC B161B/1A is not output.
Codes other than DTC B161B/1A may be output at this time, but they are not related to this check.
| *1 | Front Airbag Sensor |
| *2 | Airbag ECU Assembly |
| Proceed to |
|---|
| OK |
| NG |
OK
NG