Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR (w/ Brake pedal Load Sensing Switch) › 2017.01–2021.01
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0358159 STEERING ANGLE SENSOR(w/ Brake pedal Load Sensing Switch) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR(w/ Brake pedal Load Sensing Switch)  INSTALLATION  


PROCEDURE

Hide 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 2.INSPECT SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

Hide 3.INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

NOTICE:
·

Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.

·

Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.

·

When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel installed.



a.

Check that the ignition switch is off.


b.

Check that the spiral with sensor cable sub-assembly is disconnected from the negative (-) battery terminal.


c.

Check that the front wheels are facing straight ahead.


d.
C364105

Attach the 3 claws to install the spiral with sensor cable sub-assembly.

NOTICE:

When replacing the spiral with sensor cable sub-assembly with a new one, remove the lock pin before installing the steering wheel assembly.



e.

Connect each connector to the spiral with sensor cable sub-assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



f.
C370906E01
0.802,2.25 0.927,2.031 0.927,2.031 1.073,2.031 false 2.677,2.25 2.802,2.031 2.802,2.031 2.948,2.031 false 1.146,1.969 1.458,2.167 0.313,0.198 10 false *1 3.021,1.969 3.333,2.167 0.313,0.198 10 false *a

Connect the airbag connector and check that the slider is in the lock position.

Text in Illustration
*1 Slider
*a Lock Position

HINT:

If the slider is not in the lock position, the airbag connector is not completely connected. Disconnect the airbag connector, check the airbag connector and spiral with sensor cable sub-assembly terminals and connector housings for deformation or foreign matter, and then reconnect the airbag connector.



Hide 4.INSTALL UPPER STEERING COLUMN COVER

Hide 5.INSTALL LOWER STEERING COLUMN COVER

Hide 6. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

Hide 7.ADJUST SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

Hide 8.INSTALL STEERING WHEEL ASSEMBLY

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL