Home › Engine / Hybrid System › 1BZ-FPE (ENGINE CONTROL) › ELECTRONIC CONTROLLED CARBURETOR SYSTEM › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073136 1BZ-FPE ENGINE CONTROL _0355837 ELECTRONIC CONTROLLED CARBURETOR SYSTEM C

1BZ-FPE ENGINE CONTROL  ELECTRONIC CONTROLLED CARBURETOR SYSTEM  P0135  O2 Sensor Heater Circuit Bank 1 Sensor 1  


DESCRIPTION

Refer to DTC P0130 (Click hereEngine / Hybrid System>1BZ-FPE (ENGINE CONTROL)>ELECTRONIC CONTROLLED CARBURETOR SYSTEM>P0130).

DTC No. DTC Detecting Condition Trouble Area
P0135/21 Open or short in heater circuit of oxygen sensor for 0.5 sec. or more
(2 trip detection logic)
·

Open or short in heate r circuit of oxygen sensor

·

Oxygen sensor heater

·

Engine ECU



CAUTION / NOTICE / HINT

Read freed frame data using hand-held tester. Because freeze frame records the engine conditions when the malfunction is detected, when troubleshooting it is useful for determining whether the vehicle was running or stopped, the engine warmed up or not, the air-fuel ratio lean or rich, etc. at the time of the malfunction.

PROCEDURE

1.Check voltage between terminals HT of engine ECU connector and body ground.
A432416

a.

Remove the side trim bracket.


b.

Turn ignition switch ON.


CHECK:

Measure voltage between terminal HT of engine ECU connector and body ground.

OK:

Voltage: 9 - 14 V


Result:
Proceed to
OK
NG



OK

2.Check resistance of oxygen sensor.

NG

Check and replace engine ECU

2.Check resistance of oxygen sensor.

OK

Check and repair harness or connector between EFI main relay (Marking: EFI) and oxygen sensor and engine ECU

NG