Home › Engine / Hybrid System › N04C-WA (EMISSION CONTROL) › FUEL PRESSURE SENSOR › from 2019.08
RM2850E _51 Engine / Hybrid System _082614 N04C-WA EMISSION CONTROL _0402315 FUEL PRESSURE SENSOR A

N04C-WA EMISSION CONTROL  FUEL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89458G 1.INSTALL NO. 2 FUEL PRESSURE SENSOR

NOTICE:
·

During work, make sure that parts are free of foreign matter and water.

·

When installing parts, make sure that part connection areas are free of foreign matter.

·

If the No. 2 fuel pressure sensor has been struck or dropped, replace it.

·

After completing work, make sure to perform air bleeding, as air enters the fuel pipe during work.

Click hereEngine / Hybrid System>N04C-WA (FUEL)>FUEL SYSTEM>ON-VEHICLE INSPECTION



a.

Install a new gasket to the No. 2 fuel pressure sensor.


b.

Using SST, install the No. 2 fuel pressure sensor.

SST
09922-10010  

Torque:
Specified tightening torque : 19.6 N*m (200 kgf*cm, 14 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 133 mm (5.236 in.)) + torque wrench (fulcrum length of 162 mm (6.378 in.)): 10.8 N*m (110 kgf*cm, 8 ft.*lbf)