Home › Engine / Hybrid System › N04C-WA (COOLING) › THERMOSTAT › from 2019.08
RM2850E _51 Engine / Hybrid System _082617 N04C-WA COOLING _0403597 THERMOSTAT A

N04C-WA COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.

Install a new gasket to the thermostat.


b.
A261310C02
1.323,1.083 0.667,1.083 true 0.771,0.427 1.354,0.979 true 1.688,0.792 2.125,0.375 true 0.49,1.021 0.667,1.208 0.177,0.188 10 false *b 2.125,0.25 2.302,0.438 0.177,0.188 10 false *c 0.583,0.302 0.76,0.49 0.177,0.188 10 false *a 1.615,0.135 1.865,0.406 0.25,0.271 10 false 3°
*a Part A
*b Stopper
*c Jiggle Valve


Install the thermostat so that part A of the thermostat contacts the stopper on the inside of the case and the jiggle valve is near the top as shown in the illustration.


c.

Install the water outlet with the 3 bolts.

Torque:
28.5 N*m (291 kgf*cm, 21 ft.*lbf)


Hide 16571 2.CONNECT INLET RADIATOR HOSE

Hide 12203 3.CONNECT PCV PIPE SUB-ASSEMBLY

Hide 17341K 5.CONNECT NO. 1 INTERCOOLER AIR HOSE

Hide 58701A 8.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 33820B 9.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 58841A 10.INSTALL SHIFTING HOLE COVER (for Automatic Transmission)

Hide 58123A 11.INSTALL SHIFT AND SELECT LEVER SUPPORT WITH BOOTS (for Manual Transmission)

Hide 58420 12.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58734B 13.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58410 14.INSTALL ENGINE SERVICE HOLE COVER

Hide 58521D 15.INSTALL ENGINE SERVICE HOLE COVER MAT