1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
58521D
2.REMOVE ENGINE SERVICE HOLE COVER MAT
58410
3.REMOVE ENGINE SERVICE HOLE COVER
58734B
4.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP
58420
5.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58123A
6.REMOVE SHIFT AND SELECT LEVER SUPPORT WITH BOOTS
33506F
7.REMOVE FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY
58701A
8.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
9.DRAIN ENGINE COOLANT
53711C
10.REMOVE FRONT FENDER APRON RH
17113D
11.REMOVE NO. 1 INTAKE PIPE
17030
12.REMOVE AIR HOSE ASSEMBLY
12601B
13.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
53712C
14.REMOVE FRONT FENDER APRON LH
44360
15.SEPARATE VANE PUMP OIL RESERVOIR ASSEMBLY
44379A
16.REMOVE NO. 2 OIL RESERVOIR BRACKET
12203
17.REMOVE PCV PIPE SUB-ASSEMBLY
Slide the 2 clips and remove the pcv hose.
Slide the clip and disconnect the No. 2 pcv hose.
Remove the 2 bolts and pcv pipe sub-assembly.
11409
18.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Disconnect the 2 wire harness clamps.
Remove the bolt and engine oil level dipstick guide.
Remove the O-ring from the engine oil level dipstick guide.
17410
19.REMOVE FRONT EXHAUST PIPE ASSEMBLY
17271
20.REMOVE NO. 3 EXHAUST PIPE HEAT INSULATOR SUB-ASSEMBLY
Remove the 4 bolts and No. 3 exhaust pipe heat insulator sub-assembly.
17271
21.REMOVE NO. 4 EXHAUST PIPE HEAT INSULATOR SUB-ASSEMBLY
Remove the 3 bolts and No. 4 exhaust pipe heat insulator sub-assembly.
17505H
22.REMOVE NO. 2 EXHAUST PIPE HEAT INSULATOR SUB-ASSEMBLY
Remove the 2 bolts and No. 2 exhaust pipe heat insulator sub-assembly.
25608
23.REMOVE EGR COOLER SUB-ASSEMBLY
Remove the 2 bolts and gasket.
Disconnect the water by-pass hose and reserve tank hose.
Disconnect the No. 1 water by-pass hose and No. 2 water by-pass hoses.
Remove the 4 bolts, EGR cooler sub-assembly and gasket.
25611
24.REMOVE EGR PIPE CONNECTOR
Remove the 3 nuts and 3 spacers.
Remove the EGR pipe connector and gasket.
17505G
25.REMOVE NO. 1 EXHAUST PIPE HEAT INSULATOR SUB-ASSEMBLY
Remove the 3 bolts and No. 1 exhaust pipe heat insulator sub-assembly from the EGR cooler sub-assembly.