1.CHECK INJECTOR COMPENSATION CODE
If the injector compensation code is not correctly registered, it may cause malfunctions.
Read the injector compensation code.
Check that the compensation code of the installed injector is the same as the code registered in the ECM. If the code is not the same, register the injector compensation code on the injector.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
25608
3.REMOVE EGR COOLER SUB-ASSEMBLY
11202D
4.REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY
23741B
5.REMOVE INJECTION PIPE CLAMP
6.REMOVE INJECTION PIPE SUB-ASSEMBLY
23670
7.REMOVE INJECTOR ASSEMBLY
Remove the 5 hollow screws and 5 gaskets, and then remove the nozzle leakage pipe assembly.
After removing the nozzle leakage pipe assembly, put it in a plastic bag to prevent foreign matter from contaminating the injector assemblies.
Using a small screwdriver, remove the 4 holder seals.
Remove the 4 nozzle holder clamp bolts and the 4 nozzle holder clamps.
Arrange the holder clamps and nozzle holder clamp bolts in the correct order.
Remove the 4 injector assemblies.
Arrange the injector assemblies in the correct order.
Attach tags to identify the cylinder (#1 to #4) to the injector assemblies so that each injector assembly can be inserted into the correct cylinder during installation.
Remove the gasket from each injector assembly.
Remove the O-ring from each injector assembly.
| *1 | O-Ring |
11177
8.REMOVE INJECTION NOZZLE SEAT GASKET
Remove the 4 injection nozzle seat gaskets from the cylinder head sub-assembly.