1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
25608
2.REMOVE EGR COOLER SUB-ASSEMBLY
11202D
3.REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY
4.SET NO. 1 CYLINDER TO TDC / COMPRESSION
17113D
5.REMOVE NO. 1 INTAKE PIPE
11301K
6.REMOVE CRANKSHAFT POSITION SENSOR
58396E
7.REMOVE WIRE HARNESS CLAMP BRACKET
Disconnect the 3 clamps.
Remove the 2 bolts and disconnect the ground wire and engine wire.
Remove the 2 bolts and 2 wire harness clamp brackets.
Remove the nut and disconnect the engine wire.
Remove the 2 bolts and wire harness clamp bracket.
23802E
8.REMOVE FUEL PIPE SUB-ASSEMBLY
Remove the 4 nuts and 4 fuel pipe clamps.
Remove the 5 union bolts and 8 gaskets.
Disconnect the 2 fuel tubes.
Remove the fuel pipe sub-assembly.
23811
9.REMOVE FUEL FILTER TO INJECTION PUMP FUEL PIPE
Remove the nut and fuel pipe clamp.
Using a 17 mm union nut wrench, loosen the 2 union nuts.
Remove the fuel filter to injection pump fuel pipe.
Be sure to prevent foreign matter or water from entering the lines.
22100
10.REMOVE SUPPLY PUMP ASSEMBLY
Disconnect the 2 connectors.
Remove the nut, 2 bolts, and injection pump stay.
Remove the 4 bolts and the supply pump assembly.
Remove the O-ring from the timer cover.
13613
11.REMOVE INJECTION PUMP DRIVE GEAR
Clamp the injection pump assembly in a vise.
Remove the 2 bolts and the timer cover.
Remove the O-ring from the timer cover.
Remove the nut, injection pump drive gear and crankshaft angle sensor plate.