This DTC is stored when "Fuel Press" is low with respect to "Target Common Rail Pressure", or when the pressure limiter valve remains open.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P1266 | Supply Pump Pressure Malfunction | 1.
The pressure limiter valve is open for 17 minutes or more. (1 trip detection logic) 2.
"Fuel Press" is lower than "Target Common Rail Pressure" by the specified amount or more for 20 seconds or more. (1 trip detection logic) |
·
Open or short in injection or supply pump assembly (suction control valve) circuit ·
Injection or supply pump assembly (suction control valve) ·
Fuel filter ·
Fuel pipe ·
ECM |
Does not come on | DTC stored |
The pressure limiter valve is determined to be open when the suction control valve is stuck open.
Low fuel pressure indicates that "Fuel Press" cannot increase to the value of "Target Common Rail Pressure" for some reason. Usually, this is detected due to the injection or supply pump assembly not being able to pump an adequate amount of fuel due to a clogged fuel line, etc.
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P1266 | After warm-up, repeatedly race the engine at 3000 rpm or higher, and then idle for 17 minutes or more or maintain an engine speed of 2000 rpm for 20 seconds or more. |
Refer to DTC P0087 (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>P0087).
After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
After replacing the injection or supply pump assembly, the ECM needs initialization (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.
Disconnect the suction control valve connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B103-23 (PCV+) - B52-1 (SCV+) | Always | Below 1 Ω |
| B103-12 (PCV-) - B52-2 (SCV-) | Always | Below 1 Ω |
| B103-23 (PCV+) or B52-1 (SCV+) - Body ground | Always | 10 kΩ or higher |
| B103-12 (PCV-) or B52-2 (SCV-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the injection or supply pump assembly (suction control valve) (Click hereEngine / Hybrid System>N04C-VJ (FUEL)>FUEL SUPPLY PUMP>INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the fuel filter is not clogged.
Fuel filter is not clogged.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the clogged fuel pipe.
| Proceed to |
|---|
| OK |
| NG |
OK
NG