Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › ECD SYSTEM › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0454116 ECD SYSTEM C

N04C-VJ ENGINE CONTROL  ECD SYSTEM  P200C  Particulate Filter Over Temperature Bank 1  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P200C Particulate Filter Over Temperature Bank 1 Diagnosis Condition:

The engine must not be stopped.


Malfunction Status:

Value of the No. 4 exhaust gas temperature sensor remains at 940°C (1724°F) or higher for 5 seconds.


Malfunction Duration:

5 seconds or more


·

Monolithic converter assembly

·

Exhaust fuel addition injector

·

No. 3 exhaust gas temperature sensor

·

No. 4 exhaust gas temperature sensor

·

ECM


Comes on DTC stored

MONITOR DESCRIPTION

·

The ECM constantly calculates and accumulates the amount of soot deposit from the engine.

The regeneration mode is selected by the data based on this value and a regeneration is started.

·

If an abnormally high temperature is detected in the No. 4 exhaust temperature sensor located downstream of the monolithic converter assembly, an error is detected.


CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P200C PM forced regeneration

CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.REPLACE MONOLITHIC CONVERTER ASSEMBLY
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.


d.

Record the stored DTCs and freeze frame data.

Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>FREEZE FRAME DATA


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine / Trouble Codes.


d.

Read Current DTCs.

Result:
Result Proceed to
Value of "Exhaust Temperature B1S3" is 850°C (1562°F) or higher A
Value of "Exhaust Temperature B1S4" is 850°C (1562°F) or higher B
Other than above C




A

INSPECT EXHAUST TEMPERATURE NO. 3

B

INSPECT EXHAUST TEMPERATURE NO. 4

C