Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › ECD SYSTEM › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0454116 ECD SYSTEM C

N04C-VJ ENGINE CONTROL  ECD SYSTEM  P20CF  Exhaust Aftertreatment Fuel Injector "A" Stuck Open  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P20CF Exhaust Aftertreatment Fuel Injector "A" Stuck Open Diagnosis Condition:
·

Engine is running

·

No. 3 exhaust gas temperature is higher than 850°C (1562°F) or there is an internal malfunction in the ECM.


Malfunction Status:
·

Specified time


(1 trip detection logic)
·

Exhaust fuel addition injector assembly

·

No. 4 exhaust gas temperature sensor

·

ECM


Come on DTC stored

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P20CF PM forced regeneration did not terminate normally 3 times in a row

CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).


HINT:

P20CF may be output if the fuel has frozen during winter or in cold regions.

Check that diesel fuel appropriate for the outside temperature is being used during winter or in cold regions.

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK DTC OUTPUT
a.

Turn the ignition switch to ON and turn the ignition switch off and wait for 5 seconds or more.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine / Trouble Codes.


f.

Read the DTCs.

Result:
Result Proceed to
DTC P20CF is output A
DTC P20CF and other DTC are output B




A

2.INSPECT NO. 4 EXHAUST GAS TEMPERATURE SENSOR

B

2.INSPECT NO. 4 EXHAUST GAS TEMPERATURE SENSOR
a.

Inspect the No. 3 exhaust gas temperature sensor.

Click hereEngine / Hybrid System>N04C-VJ (EMISSION CONTROL)>EXHAUST GAS TEMPERATURE SENSOR>INSPECTION


Result:
Proceed to
OK
NG



OK

3.INSPECT EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

NG

3.INSPECT EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
a.

Inspect the exhaust fuel addition injector assembly.

Click hereEngine / Hybrid System>N04C-VJ (EMISSION CONTROL)>EXHAUST FUEL ADDITION INJECTOR>INSPECTION


Result:
Proceed to
OK
NG



OK

NG

REPLACE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY