27020
1.INSTALL GENERATOR ASSEMBLY
| *1 | Generator Bracket |
| *a | Bolt A |
| *b | Bolt B |
| *c | Bolt C |
Temporarily install the generator assembly with the bolt A.
Temporarily install the generator bracket with the bolt B to the generator assembly.
Install the generator bracket with the 2 bolts C.
125 N*m (1275 kgf*cm, 92 ft.*lbf)
Tighten the bolt A and bolt B.
55 N*m (561 kgf*cm, 41 ft.*lbf)
| *a | Nut |
| *b | Connector |
| *c | Bolt |
Install the nut to connect the terminal B.
9.8 N*m (100 kgf*cm, 87 in.*lbf)
Connect the connector.
Install the wire harnesses with the 2 bolts to the generator bracket.
8.4 N*m (86 kgf*cm, 74 in.*lbf)
| *a | Terminal Cap |
| *b | Clamp |
Install the terminal cap.
Attach the clamps.
17341F
2.INSTALL NO. 1 AIR HOSE
17700
3.INSTALL AIR CLEANER ASSEMBLY
17113D
4.INSTALL INTAKE PIPE
16361A
5.INSTALL FAN AND GENERATOR V BELT
88310A
6.INSTALL NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT
7.INSPECT FOR DRIVE BELT
58701A
8.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
33820B
9.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
58841A
10.INSTALL SHIFTING HOLE COVER
58420
11.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58734B
12.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP
58410
13.INSTALL ENGINE SERVICE HOLE COVER
58521D
14.INSTALL ENGINE SERVICE HOLE COVER MAT
15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION