While the engine is being cranked, positive battery voltage is applied to terminal STA of the ECM.
If the ECM detects the starter control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit. The ECM then illuminates the MIL and sets the DTC.
This monitor runs when the vehicle has been driven at 20 km/h (12.4 mph) for more than 20 seconds.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0617 | When conditions (a), (b) and (c) are met, positive (+B) battery voltage of 10.5 V or more is applied to ECM for 20 seconds:
(1 trip detection logic) (a) Vehicle speed is more than 20 km/h (12.4 mph) (b) Engine speed is more than 1000 rpm (c) STA signal is ON |
·
Starter relay circuit ·
Ignition switch ·
ECM |
Inspect the fuses of this circuits related to this system before performing the following procedure.
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
The following troubleshooting flowchart is based on the premise that the engine is cranked normally. If the engine does not crank, proceed to the problem symptoms table (Click here Engine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>PROBLEM SYMPTOMS TABLE).
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.
Check the value displayed on the tester when the ignition switch is turned to ON and START.
| Ignition Switch Condition | Starter Signal |
|---|---|
| ON | OFF |
| START | ON |
| Result | Proceed to |
|---|---|
| NG | A |
| OK | B |
A
B
Disconnect the ignition switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| All terminals | LOCK | 10 kΩ or higher |
| 12 (AM2) - 9 (ST2) | START | Below 1 Ω |
| *1 | Component without harness connected
(Ignition Switch) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the starter relay.
Disconnect the ignition switch connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| ST relay terminal 1 or B60-18 (STA) - Body ground | Always | 10 kΩ or higher |
| J63-9 (ST2) or B60-18 (STA) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECM connector.
Reconnect the ignition switch connector.
Reinstall the starter relay.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereEngine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>CHECK FOR INTERMITTENT PROBLEMS
NG