Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291773 CRANKSHAFT POSITION SENSOR A

2GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 19315 1.INSTALL CRANKSHAFT POSITION SENSOR

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing it.


a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.
A076417

Install the crankshaft position sensor with the bolt.

Torque:
9.0 N*m (90 kgf*cm, 80 in.*lbf)


c.

Install the wire harness clamp.


d.

Install the connector clamp.


e.

Connect the sensor connector.


f.

Confirm that the wire harness of the sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.


Hide 2.INSTALL COMPRESSOR AND MAGNETIC CLUTCH

a.

Install the compressor and magnetic clutch (See page Vehicle Interior>AIR CONDITIONING>COMPRESSOR(for 2GR-FE)>INSTALLATION).


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 4.INSPECT FOR ENGINE OIL LEAK

Hide 5.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.