Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › MASS AIR FLOW METER
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291783 MASS AIR FLOW METER A

2AZ-FE ENGINE CONTROL  MASS AIR FLOW METER  INSTALLATION  


PROCEDURE

Hide 22204 1.INSTALL MASS AIR FLOW METER

a.
A132366

Install the mass air flow meter with the 2 screws.

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing.



b.

Connect the mass air flow meter connector.


Hide 85110 2.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Install the cowl top outer panel with windshield wiper motor and link (see page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 4.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.