Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291784 CAMSHAFT POSITION SENSOR A

2AZ-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 85110 2.REMOVE COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Remove the cowl top outer panel with windshield wiper motor and link (see page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).


Hide 11102A 4.REMOVE CAMSHAFT POSITION SENSOR

A132370

a.

Disconnect the sensor connector.


b.

Remove the bolt and sensor.