Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › SFI SYSTEM › 2013.04–2014.09
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291789 SFI SYSTEM L

2AZ-FE ENGINE CONTROL  SFI SYSTEM  PRECAUTION  


NOTICE FOR INITIALIZATION


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name See procedure
Power Slide Door System (Click here)
Power Back Door System
Parking Assist Monitor System
Lighting System (w/ AFS)


NOTICE:
·

After turning engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Perform RESET MEMORY (AT initialization) when replacing the automatic transmission assembly, engine assembly or ECM (see page Drivetrain>U241E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION).

·

Perform RESET MEMORY (CVT initialization) when replacing the ECM (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION).



HINT:

Initialization cannot be completed by only removing the battery.