A flat type knock sensor (non-resonant type) has a structure that can detect vibrations between approximately 5 kHz and 15 kHz.
The knock sensor is fitted onto the engine block to detect engine knocking.
The knock sensor contains a piezoelectric element which generates a voltage when it becomes deformed.
The voltage is generated when the engine block vibrates due to knocking. Any occurrence of engine knocking can be suppressed by delaying the ignition timing.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0327 | Output voltage of knock sensor is 0.5 V or less
(1 trip detection logic) |
·
Short in knock sensor circuit ·
Knock sensor ·
ECM |
| P0328 | Output voltage of knock sensor is 4.5 V or more
(1 trip detection logic) |
·
Open in knock sensor circuit ·
Knock sensor ·
ECM |
When any of DTCs P0327 and P0328 are set, the ECM enters fail-safe mode. During fail-safe mode, the ignition timing is delayed to its maximum retardation. Fail-safe mode continues until the engine switch is turned off.
Reference: Inspection using an oscilloscope
The correct waveform is as shown.
| Item | Content |
|---|---|
| Symbols (Terminal No.) | D2-110 (KNK1) - D2-111 (EKNK) |
| Tool Setting | 1 V/DIV.
1 msec./DIV. |
| Condition | Engine speed maintained at 4,000 rpm with warming up engine |
Read freeze frame data using the GTS. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Warm up the engine.
Enter the following menus: Powertrain / Engine and ECT / Data List / Knock Feedback Value.
Read the value while driving the vehicle.
The value changes.
| Malfunction does not occur | Knock Feedback Value changes |
| Malfunctions occur | Knock Feedback Value does not change |
The Knock Feedback Value change can be confirmed by running the engine with a high load, for example, by activating the air conditioning system and racing the engine.
NG
OK
Disconnect the knock sensor connector.
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D52-2 - D52-1 | Engine switch on (IG) | 4.5 to 5.5 V |
OK
NG
Inspect the knock sensor (See page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>KNOCK SENSOR>INSPECTION).
OK
NG
Disconnect the knock sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D52-2 - D2-110 (KNK1) | Always | Below 1 Ω |
| D52-1 - D2-111 (EKNK) | Always | Below 1 Ω |
| D52-2 or D2-110 (KNK1) - Body ground | Always | 10 kΩ or higher |
OK
NG