Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › KNOCK SENSOR
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291791 KNOCK SENSOR A

2AZ-FE ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


PROCEDURE

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 11000 3.REMOVE ENGINE ASSEMBLY

a.

Remove the engine assembly from the vehicle (See page Engine / Hybrid System>2AZ-FE ENGINE MECHANICAL>ENGINE ASSEMBLY>REMOVAL).


Hide 17111 4.REMOVE INTAKE MANIFOLD

a.

Disconnect the union to check valve hose from the brake booster.


b.

Disconnect the camshaft timing oil control valve connector.


c.

Remove the wire harness clamp.


d.

Remove the union to check valve hose from the vacuum hose clamp.


e.
A229373

Remove the 5 bolts, 2 nuts and intake manifold.


f.

Remove the gasket from the intake manifold.


Hide 17135A 5.REMOVE INTAKE MANIFOLD INSULATOR

a.
A095425

Remove the intake manifold insulator from the cylinder block.


Hide 89615 6.REMOVE KNOCK SENSOR

a.
A095426

Disconnect the sensor connector.


b.

Remove the nut and sensor.