The Variable Valve Timing (VVT) system adjusts the intake valve timing to improve driveability. The engine oil pressure turns the VVT controller to adjust the valve timing.
The camshaft timing oil control valve is a solenoid valve and switches the engine oil line. The valve moves when the ECM applies 12 V to the solenoid. The ECM changes the energizing time to the solenoid (duty-cycle) in accordance with the camshaft position, crankshaft position, throttle position, etc.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0010 | Open or short in camshaft timing oil control valve circuit (1 trip detection logic). | ·
Open or short in camshaft timing oil control valve circuit ·
Camshaft timing oil control valve ·
ECM |
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the tester on.
Clear the DTC after recording the freeze frame data and DTC (See page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG) and wait 5 seconds.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P0010 is output | A |
| DTC is not output | B |
A
B
Inspect the camshaft timing oil control valve (See page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>CAMSHAFT OIL CONTROL VALVE>INSPECTION).
OK
NG
Disconnect the camshaft timing oil control valve connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D53-1 - D2-100 (OC1+) | Always | Below 1 Ω |
| D53-2 - D2-123 (OC1-) |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D53-1 or D2-100 (OC1+) - Body ground | Always | 10 kΩ or higher |
| D53-2 or D2-123 (OC1-) - Body ground |
OK
NG